Re: NSX Edge ECMP + NAT

Thanks.

Below is my proposed diagram which I am planning to implement.

In Edge I have 2 interfaces.

Interface#1 - 10.10.100.128/27

Interface#2 - 10.10.100.193/27

So from Edge Gateway perspective (ECMP Disabled) 2 equal paths to Physical Routers (R#1 & R2#)

So there are chances that the traffic may leave from Interface#1 & may get the return traffic on Interface#2

So in this case if I enable NAT in ESG will it work.

What is the recommended design in HA Mode to have single Edge Outside interface or the below design will work. ( Considering I will be using NAT in Edge GW in future)