I have used the default NAT setup. It assigned the IP address using the 192.168.130.X addresses. To my understanding, the host is acting as the virtual switch performing the NAT and allows the guests to connect to the internet but everything is isolated from other devices on the network. Again, on the same network, the guests can ping the hosts but not each other. Host cannot ping guests.
With the Host-only configuration, the IP addresses are using the 192.168.206.x network. again the same results as above, except the guests cannot reach the internet.
I am not using the bridged setting because, to my understanding, this will share the network connection with the host, which will place it on the host network